Ac Repair Cape Coral

Summers can become really hot sometimes and the upcoming summer is going to be hotter than the previous one. Have you prepared yourself for the upcoming summer season?

Prior to removing the motor from the AC, mark the position of each of the wires. The wires can be marked by placing a piece of masking tape around the wire, and writing on the tape. If masking tape is not handy, then a simple drawing of the wire locations can be made; however, do not forget to record the wire color for each connection location.

To recharge the air conditioning system on a 1999 Pontiac Grand Prix 3800 V6, the steps outlined below can be used as reference or general overview, but they are no substitute for a good maintenance manual. It is important to follow all AC repair safety procedures outlined in the vehicle owners/maintenance manual. If these procedures are not followed, serious injury or even death may result. This is a pressurized system, so precautions should be taken when performing maintenance.

Begin by noting the model and size of your A/C unit. Measure the roof opening as well. It does no good to remove the old model, and find out the new model is larger or smaller, both of which require additional construction.

If possible, oil the fan motor while you have the RV AC shroud removed. Many RV AC fan motors air conditioning repair have oiling tubes over the motor bearings. Often, the fan motor may start slowly if these bearings are not oiled annually.

This works well as long as they have 110 volt 30 amp service. Compare the price of one of these at around with an AC service absorption unit costing over a for the same capacity.

The maintenance has now been completed, and the motor can be put back into the AC. Using your hand drawn diagram, or masking tape wire markers, wire the motor back into the AC. Slide the fan-blade back onto the motor’s shaft until the fan-blade position indicating mark has been reached. Tighten the fan-blade lock-down, and give the blade a spin. It should spin effortlessly, and continue spinning for a few seconds.

Thus, replacing the thermostat can conveniently be done at home. It will take you about an hour and does not cost much either. Regularly check for faulty parts in your car and replace them if necessary, to ensure optimum performance and long life of the car.